A&J Washroom UG3-A Smooth 1-1/2" Grab Bar

A&J WashroomSKU: UG3-A36

Length (Inches): UG3-A36 - 36" Bar
Price:
Sale price$23.00

Description

A&J Washroom UG3-A Smooth1-1/2" Grab Bar
Standard finish is a #4 satin finish.
  • 1 1/2" bar diameter
  • Snap flange
  • Custom sizes available upon request
  • Powder Coating available upon request

Tubing: Fabricated of #18 ga stainless steel with a #4 satin finish. Available in 1 1/2" outside diameter. All bends are formed by an automatic mandrel bending process. All bars maintain a constant 1 1/2" offset.

Finish: Standard finish is a #4 satin finish. 

Flanges: Snap flanges are fabricated of 3" diameter, 3/8" deep drawn #22 ga stainless steel with #4 satin finish to match tubing. Flanges have dimples that secure over mounting plate.

Strength: Bars with a 1 1/2" offset clearance will support loads in excess of 900lbs when properly installed. Bars with greater offsets will support loads up to 250lbs when properly installed.

Installation: Before installing grab bars, verify with all state and local codes for requirements on bar diameter and type finish. Recommended mounting heights for grab bars are 33" - 36" centerline above finished floor. All mounting of grab bars when possible should have in wall mounting back plates. Find centerline mounting points and place bar on line making sure to be on center. Transfer mounting points (3 per flange) to wall. Drill pilot holes and secure bar with proper anchors per application. Snap cover over mounting plate.

    You may also like

    Recently Viewed